3M 1 Piece - Page 33

33
Attaching the 1 Piece (Gen 4), Cont.
Step 8:
Step 8:Step 8:
Step 8:
Place the remaining pin
tray on a flat surface and
insert measured end of
the underneath side (the
bottom) of the strap into
the pin tray.
Step 6:
Step 6:Step 6:
Step 6:
Wrap the strap around
the offender’s leg and
measure to the line
shown, so that it allows
approximately ¼ inch of
space between the
offender’s leg and the
strap to ensure comfort.
Step 7:
Step 7:Step 7:
Step 7:
Use the strap cutters to
cut the strap according to
the measurement taken in
step six.
Wipe off any fiber optic
Wipe off any fiber optic Wipe off any fiber optic
Wipe off any fiber optic
cable residue left on the
cable residue left on the cable residue left on the
cable residue left on the
strap after cutting has
strap after cutting has strap after cutting has
strap after cutting has
been completed.
been completed.been completed.
been completed.
Step 9:
Step 9:Step 9:
Step 9:
Place the 1 Piece (Gen 4) on
the offender’s leg, just
below the ankle bone, and
insert the strap with
attached pin tray into the
bracket until it snaps in
place.
Step 10:
Step 10:Step 10:
Step 10:
Press and hold the Activate Button on the front of the 1 Piece
(Gen 4) for three seconds. Note: there will be an initial, brief
feedback vibration that indicates the button is being pushed.
Continue to hold down the button.
A.
A
.A.
A. The 1 Piece (Gen 4) will vibrate once and the “PWR” LED will
begin to blink green, indicating the 1 Piece (Gen 4) is powered on.
B.
B.B.
B. The “GPS” and “ZONE” LED’s will blink green
greengreen
green once every
second. This indicates that the 1 Piece (Gen 4) is attempting to
make a wireless call.
C.
C.C.
C. The “GPS” and “ZONE” LEDs will blink green
greengreen
green twice every
second. This indicates that the 1 Piece (Gen 4) is attempting to
acquire GPS. The 1 Piece (Gen 4) must now be taken outside to
acquire GPS.
D.
D.D.
D. Once GPS has been acquired, the 1 Piece (Gen 4) will vibrate
three times. The “PWR” LED will continue to blink green
green green
green and the
“GPS” and “ZONE” LEDs will stop blinking. This indicates that
activation has been successfully completed.