9Translation of Original Instructions
GENERAL SET UP AND USE:
• Read all instructions before using this tool. All operators must be fully trained in its use and aware of all safety rules. All service
and repair must be carried out by trained personnel.
• The tool RPM should be checked on a regular basis to ensure proper operating speed.
• Make sure the tool is disconnected from the air supply and then attach 3M abrasive belt to the sander. Always wear required
safety equipment when using this tool.
• When sanding always start the tool just prior to contacting the work piece. Stop air flow to the tool as it is removed from the
work piece.
• Always remove the air supply to the sander before fitting, adjusting or removing the abrasive.
• Use only 3M approved parts.
• Prior to installing any File Belt Sander accessory, always check that its marked maximum operating speed is equal to or higher
than the rated speed of this tool.
SETTING & TESTING TOOL SPEED:
1. Ensure the Trigger is not depressed
2. Connect the compressed airline
3. Press the Trigger slowly and increase force until tool is at full speed
4. Use a Rotary Tachometer to check the speed
5. Check speed regularly
To Next Page
Loading...
