Fit Check
Performapositivepressuretcheckeachtimetherespiratoris
donned.
PositivepressureFaceFitcheck
Fitting instructions must be followed each time the respirator is
worn.
1. Placethepalmofthehandovertheexhalationvalvecoverand
exhalegently.
2. Iftherespiratorbulgesslightlyandnoairleakagebetween
the face and the respirator is detected, a proper fit has been
achieved.
3. If air leakage is detected, re-position the respirator on the
faceand/orreadjustthetensionofthestraptoeliminatethe
leakage.
4. Repeat the above face fit check
5. Ifyoucannotachieveapropert,donotenterthe
contaminated area. See your supervisor
Important Notice
3M does not accept liability of any kind, be it direct or
consequential(including,butnotlimitedto,lossofprofits,
businessand/orgoodwill)arisingfromrelianceuponany
information herein provided by 3M. The user is responsible for
determining the suitability of the products for their intended
use.Nothinginthisstatementwillbedeemedtoexcludeor
restrict3M’sliabilityfordeathorpersonalinjuryarisingfromits
negligence.
EU_Master_01
3M is a trademark of 3M company.
Pleaserecycle.©3M2013.
Allrightsreserved.
16755
3M Personal Safety Division
EMEA Region
3MCentre,
CainRoad,Bracknell
BerkshireRG128HT
UnitedKingdom
Tel:+44(0)1344858000
www.3M.eu/safety