3M Aqua-Pure AP717 - SAFETY INFORMATION; Explanation of Signal Word Consequences; WARNING; NOTICE

SAFETY INFORMATION
EXPLANATION OF SIGNAL WORD CONSEQUENCES
Read, understand, and follow all safety information contained in these instructions prior
to installation and use of the AP717 In-Line Filtration System. Retain these instructions
for future reference.
Intended use:
The AP717 systems is intended for use in ltering potable water and has not been evaluated for other uses.
The product is installed at the point of use and must be installed as specied in the installation instruction
by a qualied professional.
Indicates a potentially hazardous situation, which, if not avoided, could
result in death or serious injury and/or property damage.
Indicates a potentially hazardous situation, which, if not avoided, may
result in property damage.
To reduce the risk associated with choking:
• Do not allow children under 3 years of age to have access to small parts during the installation of this
product.
To reduce the risk associated with the ingestion of contaminants:
• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfec-
tion before or after the system.
To reduce the risk of physical injury:
• Depressurize system as shown in manual prior to cartridge removal.
• Shut off inlet water supply and depressurize system as shown in manual prior to cartridge
removal.
To reduce the risk associated with property damage due to water leakage or ooding:
• Read and follow Use Instructions before installation and use of this system.
• Installation MUST comply with all state and local plumbing codes.
• Protect from freezing, remove lter cartridge when temperatures are expected to drop below 40° F (4.4° C).
• Do not install systems in areas where ambient temperatures may go above 110°F (43.3°C).
• Do not install on hot water supply lines. The maximum operating water temperature of this lter system
is 100°F (37.8°C).
• Do not install if water pressure exceeds 125 psi (827 kPa). If your water pressure exceeds 80 psi (552 kPa),
you must install a pressure limiting valve. Contact a plumbing professional if you are uncertain how to check
your water pressure.
• Do not install where water hammer conditions may occur. If water hammer conditions exist you must
install a water hammer arrester. Contact a plumbing professional if you are uncertain how to check for this
condition.
• Do not use a torch or other high temperature sources near lter system, cartridges, plastic ttings or plastic
plumbing.
• On plastic ttings, never use pipe sealant or pipe dope. Use PTFE thread tape only, pipe dope properties
may deteriorate plastic.
• Take care when using pliers or pipe wrenches to tighten plastic ttings, as damage may occur if over
tightening occurs.
• Do not install in direct sunlight or outdoors.
• Do not install near water pipes which will be in path of a drilling tool when selecting the position to
mount the bracket.
NOTICE
NOTICE
WARNING
WARNING