Water Leaks at Push-In Connections:
Push tubing in as far as it will go. If leaking continues, shut off water at the original valve and remove water line by
pushing in on the connector collar while pulling the tubing away. Inspect tubing for cracks and scratches. If tubing is
cracked for scratched, simply cut that portion away and reinsert tubing into push-in fitting.
Make sure tubing is cut straight. If not, recut.
Water Appears Cloudy:
Flush 2.5 gallons through filter before use (approximately (5) minutes) to remove any carbon fines or trapped air in the
filter and water lines.
TROUBLESHOOTING GUIDE
SPECIFICATIONS
Model Service Flow Rate Service Life Max. Pressure Max. Temperature
AP717 0.5 gpm (1.9 lpm) 1,500 gal (5,678 lit.) 125 psi (862 kPa) 100°F (37.8°C)
To Next Page
Loading...
