3M DX70i - Connection Ports

10 3M
™
Digital Projector DX70i Product Safety Guide © 2008 3M
ENGLISH
Important Notes
 4HEPROJECTORUSESAHIGHPRESSUREMERCURYGLASSLAMP4HELAMPCAN
break with a loud bang, or turn out, if jolted or scratched, handled while
HOTORWORNOVERTIME.OTETHATEACHLAMPHASADIFFERENTLIFETIMEAND
some may burst or burn out soon after you start using them.
2. Always open the lens shutter or remove lens cap when the projection
lamp is on.
3. To avoid premature lamp failure, do not change the mounting position
OFTHEPROJECTORDESKTOPCEILINGMOUNTORCEILINGDESKTOPMOUNTAND
continue to use the same lamp.
4. To avoid reduced lamp life, do not touch projection lamp with bare
fingers.
5. To avoid reduced image quality, do not touch projection lens or other
internal optical components.
6. Do not use detergents, chemicals, or any spray liquids for cleaning this
UNITOTHERTHANTHOSEREFERREDTOINTHEh/PERATORS'UIDEv
 &ORMAXIMUMLAMPLIFEDONOTSTRIKEORDROPIMPROPERLYHANDLEOR
scratch the lamp glass. Also, do not install an old or used lamp.
 +EEPAIRFILTERCLEAN2EFERTOTHECLEANINGINSTRUCTIONSCONTAINEDINTHE
h/PERATORS'UIDEv
 +EEPALLVENTILATIONOPENINGSFREEOFANYOBSTRUCTIONS
)NSOMECOUNTRIESTHELINEVOLTAGEIS./4STABLE4HISPROJECTORIS
DESIGNEDTOOPERATESAFELYWITHINABANDWIDTHOFn6!#TO
(ZBUTCOULDFAILIFPOWERDROPSORSURGESOFÒVOLTSOCCUR)NTHESE
HIGHRISKAREASITISRECOMMENDEDTOINSTALLAPOWERSTABILIZERUNIT
Safety Information