3M DX70i - Powering On the Projector

14 3M
™
Digital Projector DX70i Product Safety Guide © 2008 3M
ENGLISH
Important Notes:
 4HEPROJECTORUSESAHIGHPRESSUREMERCURYGLASSLAMP4HELAMPCAN
break with a loud bang, or turn out, if jolted or scratched, handled while
HOTORWORNOVERTIME.OTETHATEACHLAMPHASADIFFERENTLIFETIMEAND
some may burst or burn out soon after you start using them.
2. To avoid premature lamp failure, do not change the mounting position
OFTHEPROJECTORDESKTOPCEILINGMOUNTORCEILINGDESKTOPMOUNTAND
continue to use the same lamp.
3. To avoid reduced lamp life, do not touch projection lamp with bare
fingers.
 &ORMAXIMUMLAMPLIFEDONOTSTRIKEORDROPIMPROPERLYHANDLEOR
scratch the lamp glass. Also, do not install an old or used lamp.
 7HENTHELIFEOFTHELAMPISEXCEEDEDTHE34!453INDICATORLIGHTSA
steady red and the message [Replace the Lamp Cartridge] is displayed
on the screen. When this occurs, it is time to replace the lamp cartridge.
Please make the replacement following the procedure below.
6. If the projector is used another 100 hours after the lamp’s service life is
reached, the power is set to the standby mode and no longer turns on.
Contact a store that sells the DX70i for a replacement lamp. Indicate you
NEEDA,+$8REPLACEMENTLAMPFORTHE$8I
Replacing the Lamp Cartridge