3M Peltor DECT-Com II - Page 6

4
5
Notice: All units are always started in listen only mode in group 1.
Last used alternative (base or portable) is remembered between sessions.
2.2.4 MAKE A BASE UNIT READY FOR PORTABLES TO BE REGISTERED
Each portable unit should be registered to a base unit to be part of a DECT-Com II conference.
g With the base unit in LISTEN-ONLY and VOLUME MODE, double press on the [M] button to enter
REGISTRATION MODE.
A base unit in REGISTRATION MODE is indicated by a voice conrmation “SUBSCRIPTION ON” and the LED ashing
slowly.
g When all portable units are registered to the base unit, exit REGISTRATION MODE by double pressing [M] button.
Notice: All main units are delivered open for registration from factory and a DECT-Com II system can be started directly
“out of the box” by rst starting a base/portable unit as a base as described above and after that, all portable units,
sequentially and continually, as described above.
After the rst turn off of the base unit, the conguration of the system is xed and future change of units has to be handled
according to description above.
If your system is delivered pre-registered in a certain conguration by your Authorised Peltor DECT-Com II Dealer*
)
, all
future registration has to be handled by your Authorised Peltor DECT-Com II Dealer*).
2.3 PORTABLE UNIT
2.3.1 SWITCH A PORTABLE UNIT ON
g Switch the portable unit on by pressing the [M] button.
In a headset, connected in the headset connector on the unit, a voice conrmation “POWER ON” is given and the LED on
the unit is ashing green, showing that the unit is logging on to the base.
When the unit is ready for use, a voice message “BASE #1, GROUP #1” is given and the LED is steady green.
Notice: All portable units normally start in listen only mode in group 1.
At rst start up, a voice message “SEARCHING” is given. When a base is found a voice message BASE (number),
GROUP 1” is given. When restarting a portable unit, which is programmed to be able to work with more than one base, it
will try to log on to the last used base.
2.3.2 SWITCH A PORTABLE UNIT OFF
g Switch the portable unit off by pressing and holding the [M] button for approximately 2 seconds.
A voice conrmation “POWER OFF” is given and the LED is turned off.
If the unit is still searching for a base when switching off, a voice conrmation “WARNING, POWER OFF” is given.
2.3.3 REGISTER A PORTABLE UNIT ON A BASE
Each portable unit is registered to at least one base unit to be part of a DECT-Com II conference.
The unit is searching for bases. A voice message “SEARCHING” is given.
g With the portable unit in LISTEN-ONLY and VOLUME MODE, double press [M] button to enter BASE SELECT MODE.
A portable unit in BASE SELECT MODE is indicated by ashing LED.
g When a base is selected, exit BASE SELECT MODE by briey pressing [M] button.
A voice conrmation ”BASE (number), GROUP 1” is given.