3M Peltor DECT-Com II - Page 7

6
7
Notice: All main units are delivered open for registration from factory and a DECT-Com II system can be started directly
“out of the box” by rst starting a base/portable unit as a base as described above and after that, all portable units,
sequentially and continually, as described above.
After the rst turn off of the base unit, the conguration of the system is xed and future change of units has to be handled
by your Authorised Peltor DECT-Com II Dealer*
)
.
If your system is delivered pre-registered in a certain conguration by your Authorised Peltor DECT-Com II Dealer*), all
future registration also has to be handled by your Authorised Peltor DECT-Com II Dealer*).
(See also above 2.2.4 MAKE A BASE UNIT READY FOR PORTABLES TO BE REGISTERED.)
2.3.4 LOG ON A PORTABLE UNIT TO A BASE
There are two versions of log on:
1. At rst power on (out of the box), the base unit will allow any portable unit to log on. (See 2.2.4 MAKE A BASE UNIT
READY FOR PORTABLES TO BE REGISTERED)
2. At any next start up you will automatically be logged on to the base.
When the log on sequence is nished, the LED on the unit is xed green and a voice message “BASE (number), GROUP
1” is given, conrming that the portable unit is logged on as a listen-only to the base and group with the given numbers.
! If no conrming message is given; check that the base unit is switched on and in range!
! If the message “WARNING, SUBSCRIPTION EMPTY” is given; there is no base unit registered to log on to.
! If the messages “SIGNAL LOW, OUT OF RANGE” are given; the portable unit has no connection with the base unit.
After approximately 20 seconds a message “SEARCHING” is given, indicating that the unit is searching for a base
unit. You may be too far away from the base, or the base unit is switched off!
When in contact with a base unit again; a message “BASE (number), GROUP 1” is given, conrming that the unit is
logged on to a base with the actual number.
2.3.5 LOG ON A NEW PORTABLE UNIT TO A BASE
If, later, another portable unit should be logged on to the base, the actual base unit must be set in REGISTRATION MODE
(see 2.2.4 MAKE A BASE UNIT READY FOR PORTABLES TO BE REGISTERED). The portable unit must be in SEARCH
MODE (see 2.3.6 SEARCH A BASE FROM A PORTABLE UNIT below.)
Notice: All main units are delivered open for registration from factory and a DECT-Com II system can be started directly
“out of the box” by rst starting a base/portable unit as a base as described above and after that, all portable units,
sequentially and continually, as described above.
After the rst turn off of the base unit, the conguration of the system is xed and all future change of any units has to be
handled by your Authorised Peltor DECT-Com II Dealer*
)
.
If your system is delivered pre-registered in a certain conguration by your Authorised Peltor DECT-Com II Dealer*
)
, all
future registration also has to be handled by your Authorised Peltor DECT-Com II Dealer*
)
.
2.3.6 SEARCH A BASE FROM A PORTABLE UNIT
g In BASE SELECTION MODE on a portable unit; double press on the [M] button to enter BASE SEARCH MODE.
A voice conrmation “SEARCHING” is given repeatedly, conrming that the unit is searching for active bases in range.
When a base is found a voice conrmation “BASE (number), GROUP 1” is given.
To nd more bases, repeat this procedure again.