3M Peltor Lite-Com Pro II - Accessories and Spare Parts

6
ACCESSORIES AND SPARE PARTS
Contact your Authorised Peltor Lite-Com Pro II dealer!
Notice!
When using and repairing I.S. -approved equipment, all instructions and regulations must
be followed to the letter!
HY79 Hygiene kit
Easy to replace hygiene kit consisting of two foam pads, two foam rings and snap-in ear cushions.
Replace at least twice a year to ensure constant attenuation, hygiene and comfort!
HY100A Clean – single-use protectors
A single-use protector that is easy to apply to the ear cushions. Package of 100 pairs.
HYM1000 Mike Protector
Moisture and wind-tight and hygienic tape. Protects the speech microphone and enhances its life span.
Package of 5 metres for about 50 replacements. (One metre sample is included on delivery.)
M995 Wind shield for MT53-type speech microphones
Effective protection from wind noise. Enhances the life span and protects the speech microphone.
One per package.
M40/1 Wind shield for MT7-type speech microphones
Effective protection from wind noise. Enhances the life span and protects the speech microphone.
One per package.
M60/2 Wind shield for ambient microphones
Effective protection from wind noise. One pair per package.
MT90-02 Throat microphone
Dynamic laryngophone for use with Lite-Com Pro II.
MT90-06 Throat microphone
Electret laryngophone for use with Lite-Com Pro II.
Notice!
The following accessories can be used, but MUST NOT be connected or disconnected,
in a potentially explosive environment!
MT53N-12 Electret microphone
Microphone boom with electret differential microphone.
NOTICE: Use of other type of microphone than the original model requires re-programming of the Lite-Com radio.
Contact your Authorised Peltor Lite-Com Pro II dealer for information!
MT7N-02 Dynamic microphone
Microphone boom with dynamic differential microphone
NOTICE: Use of other type of microphone than the original model requires re-programming of the Lite-Com radio.
Contact your Authorised Peltor Lite-Com Pro II dealer for information!
FL5602-50 External PTT,
ATEX approved Push-To-Talk button with connection cable for external control of transmission with the radio in the Lite-Com Pro II.
ACK08 Battery
Li-Ion battery. Intrinsically safe approved for use with Peltor Lite-Com Pro II. (One unit is included on delivery.)
Notice! Special regulations apply for replacement and charging!