3M PELTOR SCU-300 - 6.7. Fitting the SCU-300

5
9. While pressing the buttons on the RCU-300, hold the
RCU-300 against the SCU-300 to pair.
10. An audio message will indicate Primary/Secondary RCU
connected.
Note: Select Secondary remote pairing and repeat the steps
to pair a second RCU-300.
Note: To reset the RCU-300, press and hold the + and -
button on the RCU-300 for 10 seconds.
6.7. TO FIT THE SCU-300
1. Slide the metal clip onto the rails on the back of the
SCU-300.
2. Attach the SCU-300 to your protective vest according to
the illustration.
IMPORTANT! Make sure that the SCU-300 is placed in
upright position and as high as possible within the chest area.
EN