Need help?Do you have a question about the 3M RTE6701-OEM and is the answer not in the manual?
General| Brand | 3M |
|---|---|
| Model | RTE6701-OEM |
| Category | Control Unit |
| Language | English |
Important safety information, including danger, warning, caution, and notice definitions.
Legal terms and conditions for using the product, including liability limitations.
Lists trademarks of 3M and Microsoft, and acknowledges other owners.
Discusses EMC compliance responsibility and advice for system designers.
Instructions for proper disposal of the equipment according to European directives.
Guidelines for packing the product for repair or shipment, emphasizing anti-static precautions.
Details the version history of the manual, including dates and descriptions of changes.
Lists related documentation and their corresponding 3M part numbers.
Introduces the passport reader module, its OCR technology, and basic components.
Describes the typical applications and industries where the RTE6701-OEM module is used.
Lists the key features and capabilities of the passport reader module.
Instructions for obtaining and installing the resource kit, including drivers and software.
Steps to verify the installed version of the resource kit using Windows Control Panel.
Instructions for uninstalling the resource kit via the Add/Remove Programs module.
Detailed steps for installing USB drivers on Windows, including prompts and directory selection.
Guide on how to identify the virtual COM port number using the Windows Device Manager.
Steps to get an evaluation module up and running, including components and assembly.
Instructions on using the sda6700 demonstration program for testing and configuring communication settings.
Details the PCB connectors and their functions, including power, data, and read head interfaces.
Discusses design issues and manufacturing processes for integrating the module into OEM equipment.
Procedures for handling the read head, emphasizing ESD precautions and unpacking.
Recommendations for connecting the read head, including polarization and potential damage.
Critical connection details for the VC27U OEM board, focusing on the read head cable and EMC considerations.
Technical conditions and considerations for designing the document guide for optimal reading performance.
Details the standard RTE Native protocol, including data format and capabilities.
Describes the general format of data blocks transmitted to and from the reader.
Explains the format and components of the header information in data blocks.
Details the format of the text information, including line separation and character limits.
States that the BCC character is not sent in RTE Native mode.
Provides examples of data messages for passport and ID card reading.
Specifies ASCII transmission for OCR data and how unrecognised characters are handled.
Lists the OCR fonts recognised and their character sets for RTE Native protocol.
Explains how jumpers 1 and 2 configure communication parameters for RTE Native protocol.
Details jumper settings for different modes (Debug, Download) and default configurations.
Details the standard OEM protocol, including data format, character set, and flags.
Describes the data transmission format via serial port for the OEM protocol.
Specifies ASCII transmission for OCR data and how unrecognised characters are handled.
Lists the OCR fonts recognised and their character sets for OEM protocol.
Explains the meaning and possible values of the flag byte used in OEM data transmission.
Defines the rules for truncating lines to 70 characters if they exceed the limit.
Explains how vertical alignment of characters is maintained using padding.
Details how jumpers 7 and 8 set the baud rate for the OEM protocol.
Steps to install the firmware download programs and tools on your PC.
Procedure for downloading firmware to the reader module, emphasizing anti-static precautions and steps.
Alternative method to enter download mode using Hostess software if jumpers are inaccessible.
Techniques and precautions for ensuring EMC compliance when integrating the VC27U PCB.
Diagram and part details for the VC27U USB interface cable.
Diagram and details for the 10-way IDC ribbon cable connecting the read head to the PCB.
Provides dimensions and mounting details for the read head assembly.
To Next Page
