Page 15 of 39 RTE6701-OEM Integration Manual VC27U V1.03 DRAFT.doc
5 Test Programs
Assuming you have the RTE Native protocol installed you need to use the sda6700 demonstration program:
You will need to check the com port of the USB virtual comm (see section 3.5) and entering that number in the
configuration (Comms tab -> Comm Port) and also check that Native is selected (Comms tab -> Operating
Mode). Set the communications mode Comms -> Config to Manual as follows:
The exact values will depend on the firmware protocol installed and the jumper settings. Note that for other
protocols the sda6700 program will not work and you should use HyperTerminal or a similar terminal
emulator if you do not have a test program. A number of test programs are installed in the resource kit
under:
C:\Program Files\RTE\RTE 6700 Resource Kit\Development\Examples
To Next Page
Loading...