Page 13 of 39 RTE6701-OEM Integration Manual VC27U V1.03 DRAFT.doc
4 Quick Start Assembly
This section describes how to get an evaluation module up and running. For full OEM integration see
Section 7.
The kit generally comprises:
1.
The VC27U PCB
2.
An optical read head
3.
Optionally the 10 way read head cable, see Appendix C – Read Head Cable
4.
Optionally an USB interface cable (supplies power and signals), see Appendix B –
VC27U USB Interface Cable
5.
Optionally a document guide and glass window, see Section 8
Depending on what you have ordered you may have all of these or some items. Items you do not have will need
to be made by yourself. As this is an OEM product it is expected that you would manufacture items 3 to 5 once
in full production of your product, however 3M can supply you these if required.
First ensure you have all the necessary components above (all items 1 to 5).
Take appropriate anti-static precautions. Failure to observe anti-static precautions
can lead to component failure or a significantly reduced operational life.
Locate the glass window into the document guide and then install the read head on to the guide using 2 M3 x
6mm screws (note screw length may vary depending on thickness of guide). The glass window should be
gripped in place by the read head.
The screw lengths should be selected so that only 3 mm of thread enters the read
head.
To Next Page
Loading...