What to do if air leaking at retaining collar shroud assembly of 3M PPS 2.0 H/O?
If you notice air leaking at the retaining collar shroud assembly, ensure it is tightened securely. Also, check and adjust the cup pressure, making sure it doesn't exceed the maximum operating pressure of 10 psi (69 kPa 0.69 Bar).
What to do if fluid dripping from PPS™ cup of 3M Kitchen Appliances?
If fluid is dripping from the PPS™ cup, make sure that the retaining collar shroud assembly is tightened correctly. Check also that the 3M™ PPS™ Series 2.0 gun adapter is fully engaged with the lid spout. Verify that the cup pressure doesn't exceed a maximum operating pressure of 10 psi (69 kPa 0.69 Bar).
What to do if air leaking at base of cup of 3M PPS 2.0 H/O Kitchen Appliances?
If you observe air leaking at the base of the cup, verify that the safety relief valve at the base is correctly placed. Also, ensure the cup pressure does not exceed the maximum operating pressure of 10 psi (69 kPa 0.69 Bar).
How to fix a liner that does not collapse in 3M Kitchen Appliances?
If the liner isn't collapsing or collapses slowly, check the following: 1. Air inlet connection and pressure to the gun/cup. 2. Air supply port on gun to cup to ensure it's not plugged. 3. Air supply port at the base of the cup to ensure it's not plugged. 4. Cup air supply hose connection from gun to cup. 5. Retaining collar shroud assembly to ensure it's tight. 6. Safety relief valve at the base to ensure it is in place.
What to do if cup air supply hose slips off 3M PPS 2.0 H/O Kitchen Appliances?
If the cup air supply hose slips off the air supply port at the base of the cup or gun regulator, trim off the ends of the hose or replace it with air supply hose PN 16123.
General| Brand | 3M |
|---|---|
| Model | PPS 2.0 H/O Series |
| Category | Kitchen Appliances |
| Language | English |
Explains the meaning of warning and caution symbols used in the manual.
Explains the meaning of various safety symbols and their associated implications.
Step-by-step guide for setting up the 3M PPS Series 2.0 Type H/O Pressure Cup.
Illustrates a typical installation for spray guns with a separate pressure regulator.
Illustrates a typical installation for spray guns with an integrated pressure port.
Guidance on selecting and using the product appropriately for specific applications.
Outlines the product warranty terms, remedies, and disclaimers.
Specifies the extent of 3M's liability regarding product use and potential damages.
Provides details for ordering, support, and company contact information.
To Next Page