3M™ Pro-Protect + Gel Cushions Electronic Hearing Protector
90545-SIOC
QUICK-START GUIDE
This Quick Start Guide is not a substitute for the User Instructions. Before use, the wearer must read and understand the User Instructions.
1
Power & Volume:
2
Pair Device Function:
3
Once Your Device is Paired:
POWER/
BLUETOOTH
®
VOLUME
• Press and hold power button for 3
seconds to power ON/OFF headset.
• Voice Assist will announce “Power ON”
or “Power OFF.”
• Adjust ambient volume by selecting
one of the four levels by pressing the
volume button. To mute the ambient
volume, press and hold the volume
button. While muted, press the volume
button once to return to your last
volume setting.
• Performance is best when volume is set
to lowest level needed for conversation.
4
Incoming Calls, Messages,
Alerts & audio Playback:
PAUSE/PLAY
Press once
ADVANCE
TRACKS
Double-Press
Quickly
PREVIOUS
TRACKS
Triple-Press Quickly
ANSWER /
TERMINATE
CALL
Press once
REJECT A CALL
Press and hold
• To answer or disconnect a call, press
the Bluetooth
®
button once.
• To reject a call and return to Bluetooth
®
from a “3M Pro-Protect” device, press
and hold the Bluetooth
®
button.
• After disconnecting from the call, you
will hear “Call terminated.”
BLUETOOTH
®
PAIRING
POWER/
BLUETOOTH
®
• Quickly double-tap the Bluetooth
®
button to enter pairing mode.
• You will hear “Bluetooth
®
pairing.”
• Make sure your Bluetooth
®
enabled
device is scanning/searching for
devices.
• Check your device to make sure it has
discovered “3M Pro-Protect.”
• Select to connect to the hearing
protector.
5
Navigation:
BLUETOOTH
®
CONNECTED
• Once connected successfully, you will
hear “Bluetooth
®
connected.”
• Once your device has been connected
successfully to the “3M Pro-Protect,” it
will automatically link the next time you
turn on the hearing protector.
ON/OFF
Hold three seconds
POWER/
BLUETOOTH
®
Quickly double-press
to pair
SINGLE PRESS
to toggle
volume level
SINGLE PRESS
to return from mute
to last setting
PRESS & HOLD
to mute
To Next Page
Need help?
General
