EasyManua.ls Logo

3M SCOTT AIR-PAK X3 PRO User Manual

3M SCOTT AIR-PAK X3 PRO
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OPERATING & MAINTENANCE
INSTRUCTIONS
3M™ SCOTT™ AIR-PAK™ X3 PRO
CGA & SNAP-CHANGE
Pressures 2.2, 4.5, 5.5
READ ALL INSTRUCTIONS BEFORE USE
P/N 595373-01
Rev C 202004
Self-Contained Breathing Apparatus (SCBA)
NFPA-1981 (2018 Edition) Compliant

Table of Contents

Other manuals for 3M SCOTT AIR-PAK X3 PRO

Question and Answer IconNeed help?

Do you have a question about the 3M SCOTT AIR-PAK X3 PRO and is the answer not in the manual?

3M SCOTT AIR-PAK X3 PRO Specifications

General IconGeneral
PASS DeviceIntegrated PASS device
Air Supply Duration30, 45, or 60 minutes
FacepieceAV-3000 HT
ApprovalNIOSH approved
TelemetryOptional telemetry
MaterialComposite cylinder

Summary

About This Manual

Maintenance and Repairs

Guidelines for maintenance and repair, use current literature.

Safety Information

All 3M Scott Fire & Safety Products

Safety directives applying to all 3M Scott Fire & Safety products.

3M Scott Air-Pak SCBAs

Specific safety directives, warnings, and cautions for SCBAs.

CHAPTER 1 INTRODUCTION

Major Components of the Respirator

Lists key components like backframe, cylinder, facepiece.

CHAPTER 2 INSPECTING THE RESPIRATOR

Inspecting the Respirator Components

General inspection of respirator parts.

Performing Operational Testing

Testing the basic operation and alarms.

CHAPTER 3 OPERATING THE RESPIRATOR

Donning the Respirator

Procedures for putting on the SCBA.

Donning the Facepiece

Procedures for donning the facepiece.

Starting the Respirator

Steps to start the respirator and check for leaks.

Using the Respirator

Guidelines for using the respirator in operation.

Shutting Off the Respirator

Procedures to remove the facepiece and terminate use.

Replacing Air Cylinders

Steps to replace depleted air cylinders.

CHAPTER 4 CLEANING & STORING THE RESPIRATOR

CHAPTER 5 REPLACING BATTERIES

Replacing Batteries in Respirators with PASS

Steps for replacing batteries in PASS-equipped respirators.

APPENDIX F RESPIRATOR TESTING

APPENDIX G FACEPIECE FITTING

Related product manuals