Why does my 3M Motorcycle Accessories welding filter turn dark when others are welding?
To prevent your 3M Motorcycle Accessories welding filter from turning dark when others are welding nearby, try reducing the sensitivity setting. If the issue persists even at setting 1, consider using curtains or other methods to block light from other welder’s arcs.
What to do if 3M Motorcycle Accessories welding filter is locked in dark shade?
If your 3M Motorcycle Accessories welding filter stays permanently locked in a dark shade, it is likely in LOCKED mode. Simply press the SHADE LOCK button to unlock it.
Why is my 3M Motorcycle Accessories welding filter not triggering reliably?
If the 3M Motorcycle Accessories welding filter does not trigger reliably, first, remove the protective film from both sides of the outside protection plate, if there is one. Next, make sure that the 4 sensors on the front of the welding filter are not blocked by weld spatter, hands, pipes, or any objects being welded. Finally, review the sensitivity adjustment instructions to choose the correct setting for your welding process.
Why is my 3M Motorcycle Accessories welding filter pulsing light/dark?
If your 3M Motorcycle Accessories welding filter is steadily pulsing light/dark with no arc present, check the surrounding area for process or safety strobe lights. These lights can trigger welding filters from a long distance or by reflecting off ceilings, walls, or polished objects, even if the reflected light is not visible to the eye.
How to fix blurry 3M Motorcycle Accessories welding filter?
If your 3M Motorcycle Accessories welding filter is 'blurry', remove the protective film from both sides of both the inner and outside protection plates, if applicable.
What to do if 3M Motorcycle Accessories welding filter does not turn on?
To troubleshoot a 3M Motorcycle Accessories welding filter that won't turn on: - Ensure the battery is properly installed. - Verify the correct battery type is being used (CR2450N). - Replace the battery.
How to keep 3M Motorcycle Accessories welding helmet up?
To ensure your 3M Motorcycle Accessories welding helmet stays in the UP position, tighten the FRICTION setting on the side of the welding helmet.
What happens if 3M Motorcycle Accessories welding filter has spatter bonded to glass?
If the welding filter of your 3M Motorcycle Accessories has spatter bonded to the outside and/or inside glass surfaces, it means that the welding filter is permanently damaged and not covered by warranty if protection plates were not used. Always use outside and inside protection plates.
General| Brand | 3M |
|---|---|
| Model | Speedglas G5-02 |
| Category | Motorcycle Accessories |
| Language | English |
To Next Page
