3
Additional Certications
W WARNING
1. This product meets the requirements of certain industrial eyewear standards. It does not provide complete
head, eye, and face protection from signicant impact and penetration and are not a substitute for good
safety practices and engineering controls. Misuse may result in serious bodily injury or death. For
correct use, consult your supervisor and User Instructions or contact 3M Technical Service in the U.S.A. at
1-800-243-4630. In Canada, call Technical Service at 1-800-267-4414.
2. When exposed to eye and face hazards, wear additional eye and/or face protectors appropriate to the
hazard. ANSI Z87.1 – Occupational and Educational Eye and Face Protection, incorporated by reference in
the OSHA Eye and Face Standard 29 CFR 1910.133, requires safety spectacles or goggles to be worn in
conjunction with the welding helmet if the visor can be raised from the normal position during use. Failure
to do so may result in serious bodily injury or death.
When assembled according to these User Instructions, this welding helmet meets requirements of the ANSI
Z87.1.
Occupational use of this product for eye and face and/or head protection must be in compliance with applicable
health and safety standards. In the US, employers must comply with the OSHA personal protective equipment (PPE)
standard (29 CFR 1910.132) and, as applicable, the eye and face standard (29 CFR 1910.133). In Canada, consult
the applicable standard(s) for your jurisdiction.
Specications
NOTE: The 3M™ Speedglas™ Welding Helmet G5-02 is not formulated with natural rubber latex.
Table 1. Specications for 3M™ Speedglas™ Welding Helmet G5-02
Technical Data
Approximate Viewing Area
5.9 x 3 in.
150 x 76mm
Approximate Welding Filter
Battery Life
(1 x CR-2450N) 1500
Solar Assist No
Welding Helmet Weight (w/
headband and welding lter) 18.87oz. (535g)
Dark Shades 8, 9, 10, 11, 12,
Light State Shade 2.5
Switching Speed 0.1 milliseconds at 73F (23C)
Sensitivity Modes 6 levels
To Next Page
Loading...
