1. Insert the connector of the power cord into the AC
IN (AC inlet) of the projector.
2. Firmly plug the power cord into the outlet. In
a couple of seconds after the power supply
connection, the POWER indicator will light up in
steady orange.
Please remember that when the DIRECT POWER
ON function is activated, the projector will turn on
automatically when connected to power.
Connecting power supply
•
Please use extra caution when connecting the power cord, as incorrect or faulty
connections may result in re and/or electrical shock.
- Do not touch the power cord with a wet hand.
- Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
- Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
- Do not distribute the power supply to multiple devices. Doing so may overload
the outlet and connectors, loosen the connection, or result in re, electric shock
or other accidents.
- Connect the ground terminal for the AC inlet of this unit to the ground terminalof
the building using an appropriate power cord (bundled).
WARNING
√ Note
This product is also designed for IT power systems with a phase-to-phase voltage of 220
to 240 V.
AC IN
Power
cord
To Next Page
Loading...
