Remote control
Installing the batteries
Please insert the batteries into the remote control before using it. If the remote control starts to malfunction,
try to replace the batteries. If you will not use the remote control for long period, remove the batteries from
the remote control and store them in a safe place.
1. Holding the hook part of the battery cover, remove it.
2.
Align and insert the two AA batteries (HITACHI
MAXELL or HITACHI MAXELL ENERGY, Part
No.LR6 or R6P)
according to their plus and minus
terminals as indicated in the remote
control.
3. Replace the battery cover in the direction of the arrow and
snap it back into place.
WARNING
21 3
• Always handle the batteries with care and use them only as directed. Improper use
may result in battery explosion, cracking or leakage, which could result in re, injury
and/or pollution of the surrounding environment.:
-
Be sure to use only the batteries specied. Do not use batteries of different types
at the same time. Do not mix a new battery with used one.
-
Make sure the plus and minus terminals are correctly aligned when loading a
battery.
-
Keep a battery away from children and pets.
-
Do not recharge, short circuit, solder or disassemble a battery.
-
Do not place a battery in a re or water. Keep batteries in a dark, cool and dry place.
-
If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
-
Obey the local laws on disposing the battery.
To Next Page
Loading...
