3M XT-1 - Page 21

Installation
3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
March 2014 – Revision 2.0
Page 21 of 74
Figure 6
• Attach the base station to the wall using screws and possibly wall
anchors.
Note:
Steps 3 and 7 assume that all of the communication cabling has been prepared
and is available at the base station. If not, see “Base Station to Component
Wiring,” page 24.
• Follow local best practices and any applicable regulations to route the
cables into the base station cabinet’s top, sides, or back (through the
wall) as neatly as possible. Do not route power supply wiring with
communication wiring in the same conduit.
• Attach all cables to their appropriate terminals.
• Connect the base station transformer between the wall outlet and the
base station power supply connection.
Connect the Components
This section provides diagrams and information that should help you to properly
wire the system components together.
Note:
In all cases, you must have one base system for each order point (i.e., you
cannot run two or more order points from a single base station).
Base Station Wiring Terminal Identification
Figure 7 identifies all of the wiring terminals and their labels. The table that
follows provides definitions of the labels and identifies where they should be
connected in the system.