Installation
3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
March 2014 – Revision 2.0
Page 25 of 74
Figure 8
Figure 9 shows the wiring configuration between a base station and the
components of a single drive thru. In systems with two base stations, use this
wiring diagram for each of the stations, then see “Base Station to Base Station
Wiring,” Page 27.
Note:
Vehicle Detector 1 (VEHDET.1) must always be used for proper base station
operation. Vehicle detectors 2 and 3 (or any integral detectors installed with
optional modules) can be used at your discretion.
To Next Page
Loading...
