Configuration
3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
March 2014 – Revision 2.0
Page 45 of 74
Drive Thru Audio Duplex Mode
The system can function using half duplex or full duplex modes. Choosing
between the two modes is based upon the desired operation.
Note:
In half duplex installations, all latching order taking modes and hands free
mode are disabled.
Perform the following procedure to change the drive through audio mode:
• Enter the base station configuration mode, see page 35.
• Change the value for 07 Global Settings > DriveThru Audio
Duplex Mode to Full or Half.
• In half-duplex systems, when the order taker is speaking, it is
impossible to hear any speech coming from the customer order
point.
• In full-duplex systems, the order taker can speak and hear speech
coming from the customer order point at the same time.
Page Channel Heard by Order Taker
You can enable or disable the order taker from being able to hear any paging
while speaking to a customer over the customer order point. This may prevent
interference with the order taking process.
Perform the following procedure to enable or disable the order taker hearing
pages while talking:
• Enter the base station configuration mode, see page 35.
• Select 07 Global Settings.
• To enable or disable the monitor playing the outbound talk, change the
value for PAGE Channel Heard by Order Taker: to NO or YES.
Number of Base Stations at this Site
When there are two base stations used together (tandem, dual, or side-by-side
drive thrus) they must be configured to work together.
Perform the following procedure to enable the two stations to work together:
On the base first station:
• Enter the base station configuration mode, see page 35.
• Change the value for 07 Global Settings > Number of
BaseStations at This Site to 2.
• Press Enter to implement the change.
• On the first base station, stations, change the value for 07 Global
Settings > Lane Number of This Base Station to 1.
On the second base station:
• Enter the base station configuration mode, see page 35.
• Change the value for 07 Global Settings > Number of Base
Stations at This Site to 2.
• Press Enter to implement the change.
• On the second base station, stations, change the value for 07 Global
Settings > Lane Number of This Base Station to 2.
To Next Page
Loading...
