4RF Aprisa SR+ - 5 Default Configurations; Aprisa SR+ Radios; Channel Access; Security

Default Configurations | 11
Aprisa SR+ Demo Kit Guide 1.3.0
5. Default Configurations
The Aprisa SR+ Demo Kit has been preconfigured to specific parameters in keeping with the
demonstrations outlined in this document.
Should at any stage parameters be changed and a reset to the original state is required, the following
procedures may be used.
Aprisa SR+ Radios
The demo kit radios have been preset with User Defaults. The radio settings can be reset to these
defaults if required.
1. On SuperVisor, click on Maintenance > Defaults > Restore User Defaults. When activated, all radio
parameters will be set to User Defaults.
The configurations set have been detailed below:
Channel Access
Access mode:
access request
Default/Serial/Ethernet
Packet Time-to-live (ms):
0
Default/Serial/Ethernet
Packet back off (ms):
4 or 2
Security
ICMP:
enabled
Serial Port Settings
Baud rate:
115200
Data Bits:
8
Parity:
n
Stop Bits:
1
Flow Control:
RTS/CTS
Ethernet Settings
Ethernet Port 1:
User+ Management
Ethernet Port 2:
User+ Management
Ethernet Bridge OTA:
Enabled