70mai A200 - Package Contents; Installation

4
Package Contents
If you purchased the dash cam only, check the following items in the package:
• Dash cam
• Mount
• Power cord
• Car charger
• Electrostatic sticker ×2
• Adhesive sticker
• Wiring trim tool
If you purchased the dash cam set, check the following items in the package:
• Dash cam
• Mount
• Power cord
• Car charger
• Electrostatic sticker ×2
• Adhesive sticker
• Wiring trim tool
• Rear camera package*
*) This package contains the rear camera (integrated with lead wire), signal wire and other
accessories for the rear camera. For more information, please refer to the rear camera user
manual.
Installation
First, install the electrostatic sticker. Paste the electrostatic sticker on the
recommended area of the front windshield. Press the sticker to remove air bubbles out.
Avoid the edge of the windshield and select the flat and smooth area for the installation.
Note: Keep the windshield clean and dry without liquid residue to prevent the sticker
from losing adhesion and dash cam from dropping.
Next, install the mount. Attach the mount to the mount slot and slide up.
Install the memory card. Insert the memory card into the memory card slot.
Mount the dash cam. Paste the dash cam onto the electrostatic sticker.
Route the cables. Route the power cord to the vehicle’s power outlet and connect to
power. Start the car engine and the dash cam will automatically turn on.
Finally, adjust the camera angle. Adjust the camera angle based on the image
presented on the main screen when dash cam is turned on.