PROBLEM
The robot floats on the surface.
The robot does not clean all areas of the pool.
The robot does not recover debris during operation.
Fine particles (dust or dirt, pollen ...) are ejected by
the impeller.
- Immersion of the robot in the pool.
- Basket clogged/full
- An object is stuck in the turbine or the grid located
above the turbine.
- Use of the fine filter.
- Water level in the pool.
- Pool size may be larger than maximum pool size
listed on Product Features
- An object blocks the rollers, the wheels of the robot
or hinders the movement of the robot.
- The robot does not receive enough power.
- Basket clogged / full.
- An object is stuck in the impeller or the grid located
above the impeller.
- Debris are too fine, the robot is made to pick up
the particles more than 50 microns (with the fine
filter inside the basket).
CAUSE(S)
- When you put the robot in the pool, let it sink and
reach the floor before you turn it on.
- Check that the impurity collection basket is not full.
- Check that there are no foreign objects in the
turbine or blocked in the grille above the turbine.
- If you use an optional fine filter, remove the filter
from its plastic wrap, immerse the filter in the water
so that it is already wet before you put it in the
robot and let the robot settle on the floor before
you turn it on.
- If your pool water level is too high, the robot might
turn around and take in the air if it touches the top
seats, in this case to adjust the level of the pool.
- Fully charge your battery pack and run another
cleaning cycle.
- Our robots are designed to facilitate the
maintenance of your pool/ However, they are not
intended to be the sole tool used to clean a pool
fully of algae and leaves (ex: end of winter period).
Additional tools and cleaning cycles will be needed.
- Insert the robot at the center point of the pool.
If your pool is oval or rectangular, this point is the
middle of the length.
- Check that there is no foreign object blocking the
hydraulic circuit or the brushes and belts under the
robot and on the sides.
- Check the connection of the cables.
- Clean the basket and filter panels. Clean the fine
filter if you use this accessory.
- Check if the basket is properly inserted. (See
chapter Cleaning of the filter basket).
- Check that there are no foreign objects in the
impeller or blocked in the grid above the impeller
- Check the attachment of the basket, press it if
necessary to lock it.
- Use a fine filter (check item number on the parts
drawing 20, sku 71170) on the other hand do not
forget that it is the filtration of your swimming pool
which ensures the cleaning of the particles of less
than 50 microns.
SOLUTION(S)
08 Troubleshooting
Page 11
EN
08 TROUBLESHOOTING
To Next Page
Loading...
