EN
4.12 A the end of the cleaning cycle the robot will move to an edge of your
pool. Use the retrieval hook supplied with your cleaner to remove
the cleaner out of the your pool. The tool is designed to hook onto
the handle of the cleaner. When the cleaner is close to the surface of
the water, use you hand to grasp the handle of the cleaner. Slowly lift
the cleaner out of the pool and let the water drain out of the cleaner.
04 START-UP / 05 CLIMBING WALLS
4.13 Do not remove your robot out of water immediately after
the end of its cleaning cycle so as not to cause a
temperature shock.
4.14 When the cleaner is no longer used for an extended period,
screw on the protective caps and store your robot and
battery pack indoors.
Page 8
In order to be efficient while
cleaning the waterline, the
robot is designed to climb up
the waterline with the
orientation that offers the most
effective brushing.
It is therefore normal to see it
climb to the waterline only by
the side with the handle.
05 Climbing Walls
To Next Page
Loading...
