EasyManua.ls Logo

8STREME 7320 - Troubleshooting Common Issues; Robot Buoyancy and Cleaning Coverage

8STREME 7320
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
PROBLEM
CAUSE(S) SOLUTION(S)
10 TROUBLESHOOTING
10 TROUBLESHOOTING
Page 13
The robot floats on the surface.
The robot does not clean all areas of the pool.
The robot does not recover debris during operation.
Fine particles (dust or dirt, pollen ...) are ejected by
the impeller.
- Immersion of the robot in the pool.
- Use of the fine filter.
- Water level in the pool.
- Not enough / too much cable floating in the pool.
- The robot does not receive enough power.
- Basket clogged / full.
- An object is stuck in the impeller or the grid located
above the impeller.
- Debris are too fine, the robot is made to pick up
the particles more than 50 microns (with the fine
filter inside the basket).
- When you put the robot in the pool, let it sink and
reach the floor before you turn it on.
- If you use an optional fine filter, remove the filter
from its plastic wrap, immerse the filter in the water
so that it is already wet before you put it in the robot
and let the robot settle on the floor before you
turn it on.
- If your pool water level is too high, the robot might
turn around and take in the air if it touches the top
seats, in this case to adjust the level of the pool.
- Make sure the length of floating cable introduced
in the pool is just the required length.
- Remove any excess cable length from the pool and
leave this excess length outside the pool next to the
power supply box.
- Insert the robot at the center point of the pool.
If your pool is oval or rectangular, this point is the
middle of the length.
- Check the connection of the cables.
- Clean the basket and filter panels. Clean the fine
filter if you use this accessory.
- Check if the basket is properly inserted. (See
chapter Cleaning of the filter basket).
- Check that there are no foreign objects in the
impeller or blocked in the grid above the impeller
- Check the attachment of the basket, press it if
necessary to lock it.
- Use a fine filter (check item number on the parts
drawing 29, sku 71170) on the
other hand do not forget that it is the filtration of
your swimming pool which ensures the cleaning of
the particles of less than 50 microns.

Related product manuals