EN
05 START-UP / 06 CLIMBING WALLS
Page 9
5.11 For optimal performance, place your robot
in the pool at the furthest possible location
from the power source.
This is the appropriate length of the cable so
that the robot can reach all of your pool.
Limit the length of cable in the pool to the
bare minimum, and place the surplus outside
the pool.
5.12 To turn off your robot, press the power
button and hold for 3 seconds.
Alternatively, you can also press the switch
located on the side of the box, under blue
light.
5.13 Do not remove your robot out of water
immediately after the end of its cleaning
cycle so as not to cause a temperature
shock.
5.14 When the cleaner is no longer used for an
extended period, screw on the protective
cap on the power supply and store your
robot indoors.
In order to be efficient while
cleaning the waterline, the robot
is designed to climb up the
waterline with the orientation
that offers the most effective
brushing.
It is therefore normal to see it
climb to the waterline only by
the side with the handle.
06 Climbing Walls
To Next Page
Loading...
