Instruction manual SGE 61
gis
8.5 Anode warning
This message appears when the anode protection is
no longer active. If the message appears, you must
contact your service and maintenance engineer.
Note
The water heater continues to function when this
message appears.
8.6 Q/T Sensor warning
This message appears if the Q/T sensor has not been
connected (properly) but has been selected in the
service programme (12.10.5 "Setting the Q/T
sensor"). If the message appears, you must contact
your service and maintenance engineer.
8.7 Collector temperature warning
This message appears whenever the collector
temperature is too high. This message disappears
automatically. If the message does not disappear, you
must contact your service and maintenance engineer.
!!! WARNING !!!
POWER ANODE
MALFUNCTION
!!! WARNING !!!
Q/T SENSOR NOT
CORRECTLY CONNECTED
!!! WARNING !!!
TEMPERATURE
COLLECTOR
TOO HIGH
To Next Page