To Next Page

To Previous Page

FabriPulse

2015 American Air Filter Company, Inc. Any use of the text or

images this document contains, without permission of American Air

Filter Company, Inc., is prohibited. FabriPulse, AAF, REDClean,

REDFiltration, and Reliable Efficient Durable are registered

trademarks of American Air Filter Company, Inc. d/b/a AAF

International.

Typical Explosion Vent Installation.

To ensure proper installation of your explosion vent, carefully read the

separate manufacturer’s explosion vent installation guide.

WARNING: personal injury, death, and/or property damage can result from

material discharge during venting.

10.3 Explosion Vent Burst Sensor

All standard explosion vents come with a burst sensor. This can be

connected to an AAF Control Center or to the customer’s controls to shut down the

unit when an event occurs.

The magnetic sensor is suitable for use in Class I and II, Division I, Groups A

to G.

Under normal operation, when the disk is closed, the switch is closed. When

the disk opens, the switch opens (no electrical flow).

The connection cable is two wire, 3 feet long and has a voltage of 30VDC

and current of 10 mA. This cable will be wired on site.

To ensure proper installation of your explosion vent, carefully read the

separate manufacturer’s explosion vent installation guide.

Questions and Answers:

Need help?

Do you have a question about the AAF FabriPulse M and is the answer not in the manual?

AAF FabriPulse M Specifications

General