36
2015 American Air Filter Company, Inc. Any use of the text or
images this document contains, without permission of American Air
Filter Company, Inc., is prohibited. FabriPulse, AAF, REDClean,
REDFiltration, and Reliable Efficient Durable are registered
trademarks of American Air Filter Company, Inc. d/b/a AAF
International.
Dust build-up in hoppers
Dust build-up into the bag area will result in excessive abrasion on the bags.
The build-up may be caused by a malfunction of the discharge device or
condensation in the hopper. A hopper vibrator or hopper heaters with
insulation may have to be added to the hoppers.
Bag wear on the inside
Dirt on clean side of bags will wear the bags out from inside. This could be
the result of a broken bag, or incorrect bag installation or an improper tube
sheet seal. Vacuum the clean air side, replace the bag, correct the seal, and
reseal the header. Do not blow dirt inside the bags. If the bags have dust
inside them, vacuum them out or replace them.
14 RECOMMENDED SPARE PARTS LIST
The following is the recommended spare parts list to have on hand at all
times:
2
3
4
5
6
6’ Bag Assembly
Diaphragm Valve Repair Kit
Pilot Valve Repair Kit (NEMA 4)
Controller
Door Gasket
1 Assembly
I Kit Required
1 Kit Required
1 Control
10 ft.
To Next Page
Loading...
Need help?
General
