What to do if A&D GF-300 show overload error?
If the A&D Scales display shows an overload error, it means that the sample placed on the pan exceeds the weighing capacity. Remove the sample from the pan.
How to fix stability error on A&D GF-300 Scales?
If your A&D Scales show a stability error, it indicates that the balance cannot stabilize due to an environmental issue. Try to prevent vibration, drafts, temperature changes, static electricity, and magnetic fields.
What does internal error mean on A&D Scales?
If the A&D Scales are showing an internal error, it indicates an issue found during the self-check function. Repair is required, so contact your local A&D dealer.
How to resolve communications error on A&D GF-300 Scales?
If you receive a communications error on your A&D Scales, it means a protocol error occurred during communication. Double-check the format, baud rate, and parity settings.
What to do if A&D GF-300 memory is full?
If the A&D Scales display a 'Memory full' error, it signifies that the weighing data has reached its maximum capacity. To store new data, you must delete existing data from the memory.
How to fix format error on A&D GF-300 Scales?
If the A&D Scales display a 'Format error', it means a command includes incorrect data. Check the command and correct any errors.
What does timeout error mean on A&D Scales?
If the A&D Scales show a 'Timeout error', it means the balance didn't receive the next character of a command in the one-second time limit. Check the communication setup.
How to resolve undefined command error on A&D GF-300 Scales?
If the A&D Scales displays an 'Undefined command error', it means the device received a command that it doesn't recognize. Check the command being sent to the scales and ensure it is a valid command.
What to do if A&D GF-300 Scales show excess characters error?
If the A&D Scales show an 'Excess characters error', it means the balance received too many characters in a command. Verify the command being sent.
How to fix parameter setting error on A&D Scales?
If the A&D Scales display a 'Parameter setting error', it means the received data is outside the acceptable range. Check the command's parameter range.
To Next Page
General