A&D TM-2440 - A-BPM Preset Programs

37
Hour
Clock
Hour
xx
xx = 0 to 23 hour
Minute
Clock
Min.
xx
xx = 0 to 59 minutes
Enclosed characters : Factory settings and initial settings when
batteries are consumed completely.
8.2.3. Initial Pressurization Value
The initial pressurization value is set to 180 mmHg at the factory.
8.3. A-BPM Preset Programs
The initial settings can be configured using the following methods.
The method to use switches on the recorder.
The method to use dedicated peripheral that is connected to the
recorder using the USB cable.
A-BPM can use only while the automated measurement can be
performed.
Procedure of operation using switches
Step 1. If the indication of the display is hidden, press the START/STOP
or EVENT switch to return to the display of waiting mode.
Step 2. If the mark is shown, press and hold the EVENT switch for
3 seconds or more to suspend A-BPM.
The
mark turns off.
Step 3. While holding START/STOP switch, press and hold the
EVENT switch for 3 seconds or more. Sleep will display on
the OLED display.