A&D TM-2440 - Initial Settings; Factory Settings

35
8.2. Initial Settings
8.2.1. Factory Settings
The factory settings (initial settings) are described below :
Common items of the settings
Item Factory setting
Monitor function ON (is indicates them)
Year, Month, Day, Hour, Minute Date of shipment
Items of A-BPM
Item Factory setting
Sleep mode OFF
Interval time when the sleep mode is ON 30 minutes
Start time of the section 1 0 hour
Interval time of the section 1 30 minutes
Start time of the section 2 0 hour #1
Start time of the automated measurement OFF
Operation time of the automated measurement OFF
The content of the factory settings
When the EVENT switch is pressed and held for 3 seconds or
more, A-BPM is started. Blood pressure is measured every 30
minutes until A-BPM is suspended by pressing and holding the
EVENT switch for 3 seconds or more again.
#1 : The settings between the interval time of the section 2 and the
interval time of the section 6 are omitted because the start time
of the section 1 and 2 is the same value.