24
Housing case
Clean the case gently using a soft cloth moistened with water and mild detergent or alcohol.
Display panel
Clean the display gently so as not to scratch the panel surface. Use a soft cloth moistened with water.
Arm cuff cover
When the arm cuff cover becomes dirty or it is worn out, replace with a new one. Refer to “9-1 Replacing
the Arm Cuff Cover”.
Note
If the cover is not installed properly, it may cause problems in operation.
9-7 Options and Consumables
Options and consumables available for the TM-2655/TM-2655P are shown below. Order them from the
nearest dealer. Use the part numbers when ordering.
Table·····································································TM-9325
Chair without backrest (Gas shock suspension)···TM-9312A
Chair with backrest (Gas shock suspension)········TM-9315A
Printer paper (5 rolls) ··········································· AX-PP147-S
Arm cuff cover ·························································· AX-133003442-S
Power cable (cord set) ············································· AX-KO243 (Type C)
Power cable (cord set) ············································· AX-KO242 (Type BF)
Power cable (cord set) ············································· AX-KO115 (Type A)
To Next Page
Loading...
