Aastra 470 - Page 14

Configuring the application card
14
Applications Card CPU2
syd-0421/1.2 – R2.1 – 07.2012
Settings under IP Network
You will find the IP network settings here.
IP network adapter settings
Settings under Licencing
If you have purchased additional licences, you can read the new licence data here:
1. Load the OIP licence data on the application card by clicking the Browse button
on the OIP line and searching for and choosing the licence data via the data
dialogue on your data storage device. Load it in the same way as for the TWP
licence data.
2. Click Applyto upload the licence data.
Licence data upload might take a while.
The lower part of the licence screen gives you an overview of the number of
activated licences used and the number of licences that are still free. Click Refresh
to refresh the display.
Note:
Check whether you have assigned each user the required CTI applications
in the communication server user configuration.
Parameter Explanation
Device Name of the network adapter integrated into the application card (read only
access).
MAC address MAC address of the network adapter integrated into the application card
(read only access).
DHCP enabled DHCP is activated (standard value)
IP address / Subnet mask Application card IP address and subnet mask. If DHCP is disabled, the
standard value is 192.168.104.014.
Note:
If you disable DHCP and statically address the application card, please note
that the application card IP address must be on the same subnet as the
communication server IP address.
Gateway Subnet standard gateway
Primary DNS / Secondary DNS Indicate here the DNS servers to be queried for name resolution, and in which
order. If you have only one working DNS server, leave the Secondary DNS
input field blank.