Need help?Do you have a question about the Aastra 9110 and is the answer not in the manual?
Provides basic telephone service during power failures.
Lists all items included with the telephone.
Indicates ringing, call on hold, or message waiting.
Stores numbers or features for quick access.
Activates speakerphone and allows microphone muting during calls.
Used for network features like Call Waiting and Three Way Calling.
Dials the last number that was dialed.
Used to store numbers or features into memory keys.
Attaching the coiled handset cord to the handset and telephone.
Plugging the telephone line cord into the phone and wall jack.
Instructions for attaching the telephone stand for desk placement.
Routing the line cord along the groove on the telephone stand.
Procedure for mounting the telephone on a wall using a mounting plate.
How to mount the phone on a wall using the attached stand.
Placing the telephone number card under the handset cradle.
Inserting the memory key card into its designated slot on the telephone.
Steps to place a regular call using the handset or speakerphone.
Procedure for answering an incoming call.
How to put a call on hold and retrieve it.
Instructions for making calls using speakerphone mode.
Turning the microphone off during a handsfree call.
Dialing the last number that was dialed.
How to change handset, speaker, and ringer volume levels.
Explains the meaning of indicator light flashes and illumination.
Procedure for saving up to 7 speed dial numbers.
Writing names on the memory key card for identification.
How to dial numbers stored in memory keys.
Steps to remove stored numbers or features from memory keys.
Storing feature codes for services like Call Forwarding.
Activating or deactivating features programmed into memory keys.
Connecting external devices like fax or modem to the phone.
Check handset cord placement in the stand channel.
Some keys may be factory-programmed and cannot be changed.
Press Flash to answer Call Waiting; may require service subscription.
Ensure line cord and receiver cord are properly connected and undamaged.
Normal to hear dial tone while saving/erasing numbers in memory keys.
Wait a few seconds after ending a handsfree call before initiating a new one.
To Next Page
General
