Aastra DIALOG 4223 PROFESSIONAL - Sending a Mini-Message

Message Services
MD Evolution – Dialog 4223 Professional
60
Sending a Mini-Message
Suppose you attempt to contact someone who either does not
answer his/her extension, or whose extension is busy.
Over and above the other operations available to you during outgoing
calls (see “Operations for Outgoing Calls” section), you may also
end your call by sending a mini-message to the called extension,
if it is compatible with this service.
To do so, no matter what the status of the requested party:
>> Press the Next key to display the following screen:
MSG+DISC Then press the dynamic function key shown on the left.
Your extension then prompts you to select the mini-message to
send to your party.
NEXT Press the dynamic function key shown on the left.
This will allow you to scroll through the various available mini-
messages. By default, the messages available are: “HAS CALLED
YOU BACK”, “WILL CALL BACK” and “WOULD LIKE TO SEE
YOU” (see also other messages available, described later).
SELECT Press the dynamic function key shown on the left to select
the mini-message to send.
Your extension’s screen displays the following:
CONFIRM Press the dynamic function key shown on the left to validate
your selection.
This ends your call immediately upon sending the associated mini-
message.
L1 SMITH Peter-405
WAIT
DTMF CALL_BACK FLASH >
L1 SMITH Peter-405
WAIT
MSG+DISC <
L1 SMITH Peter-405
0 -> HAS CALLED YOU BACK
SELECT NEXT RETURN
L1 SMITH Peter-405
WOULD LIKE TO SEE YOU
CONFIRM RETURN