AAXA Technologies P400 - Getting Started Guide; Powering Projector On and Off

Getting Started
1. Connect the power cord to the P400.
2. Connect the other end of the power cord into the wall power source.
3. Toggle the On / O󰀨 switch on the side of the projector to the “ON” position - the
projector should automatically turn on.
4
Powering ON the projector
Chapter 2
Powering OFF the projector
1. To turn o󰀨 the projector, toggle the “Power Switch” to the “OFF” position. This will
fully turn o󰀨 the projector.