want to use, then press OK to confirm the setting.
ØØ Add
You can press the Red button to add a transponder. Here you can input new
Transponder frequency, choose polarization (Ver, Hor), input new symbol rate,
and choose FEC (1/2, 2/3, 3/4, 6/5, 7/8, Auto). And press OK to confirm the
settings, and then this new Transponder will be added to the TP list in ascend
order sorted by frequency.
ØØ Delete
You can delete the Transponder of the satellite. Select the Transponder that you
want to delete from the TP list. Then press the Green button. You will be asked
to confirm whether delete the satellite or not. If you select YES, all the channels
in the selected Transponder will be deleted, and the selected Transponder will
disappear.
ØØ Edit
Press Yellow button to edit. Here you can set the Transponder frequency,
polarization, symbol rate and FEC.
ØØ Delete All
Press the button. You can delete all the channels and Transponder in the
selected satellite will be deleted.
3.1.3 Search Channels from Satellite
A: Satellite Search
1. Highlight the Satellite and press the OK button to enter satellite list. And then
select one satellite you want to search.
2. Complete the antenna settings of this satellite.
3. Highlight the Start Search and select satellite then press the OK button to
confirm.
B: Multi Satellites Search
1. Highlight the Start Search and select Multi satellites then press the OK
button.
2. Highlight the satellites in the satellite list, but make sure they are all
To Next Page
Loading...
