press OK on a Highlighted channel. If you set
OFF
, the channel list will
disappear when you press OK on a playing channel.
14.Source Signal Type: Set the DVB-T/T2 signal type.
15. Recall List: You can turn Recall List on or off. If you set ON, when you press
Recall button of RCU you can get the recall list. If you set OFF, when you press
recall button you can go back to the last program you have selected.
16. Low Power Standby：You can turn Low Power Standby on or off.
17. PLSN Super Scan：you can set yes or on.
18.Front Panel Light: Set the brightness of the LED.
19. Front Panel Display: Set the LED display channel or clock.
20. Front Panel Scroll Mode: Here you can set on ,Always,Once or No Scroll.
21. Channel List Typ: Here you can set the channel list type wide or simple.
22. Network auto update: Set the SW update by network if automatic or not.
23.CI Message: Here you can set to show the CI message or not.
6.2 OSD Setup
Menu->SETTINGS->OSD Setup
1. Menu Transparency: Set the transparency of all menus.
2. TXT Transparency: Set the transparency of teletext.
3. Display Mode: Set the HD
format between 1080p, 1080i,
720p, 576i or 576p.
4. TV Type: Set the TV Type on
PAL/NTSC/Auto state.
5. Screen Mode: Set the display
format according to the screen
ratio. Select TV
screen mode either 4:3 or 16:9
according to the TV type, or press
the MODE button of RCU directly.
To Next Page
Loading...
