2
Contents
Important
Safety instruction1.1 3
4
4
4
5
6
8
9
14
15
16
1.2
1.3
1.4
2.1
3.1
3.2
4.1
5.1
6.1
7.1
Waste disposal
Environmental protection
Battery note
Front panel/ Rear panel
Remote control(RCU) / Buttons
Information about RCU and batteries
First installation / Installation Wizard
OSD display
Product description
Declaration of conformity
Please read this manual carefully and keep it.
We expressly reserve the right to make technical changes or changes in operation - which
serve to improve the device or which increase the safety standard - even without a separate
announcement.
An E2 Linux Receiver is very extensive and is developed every day. Therefore,it is very
difficult to create a manual according to the current state. The manual was created based
on the software version openATV 6.4.
A function can change, evolve or even disappear after a certain amount of time.
The actual appearance of the product may differ from the photograph of the instructions
and on the packaging.
All information is provided without warranty. Printing errors,mistakes and changes reserved.
This document may only be reprinted or copied in whole or in part with the express,
written approval of the manufacturer. Any type of reproduction,distribution,translation
or transmission in any form,electronically or mechanically,including photocopying,
recording or storage on data media without the approval of the manufacturer,violates the
applicable copyright laws and will be prosecuted.The copyright of these operating
instructions remains with the manufacturer.
To Next Page
Loading...
