Need help?Do you have a question about the ABB 07CT41 and is the answer not in the manual?
General| Brand | ABB |
|---|---|
| Model | 07CT41 |
| Category | Controller |
| Language | English |
Discusses regulations for installation setup, including VDE standards and environmental conditions.
Details CS31 bus parameters like type, topology, length, refresh time, and baud rate.
Compares technical specs of 40 and 50 series basic units regarding I/O, interfaces, and memory.
Details program execution times, operand limits, programming software, and languages.
Lists weight, power requirements, current draw, and digital input specifications for basic units.
Provides details on integrated outputs, including number, type, current ratings, and protection.
Details weight, power, consumption, and digital input specs for ICMK series units.
Provides specifications for integrated outputs of ICMK series units, including current, protection, and switching.
Lists specifications for digital extensions like weight, inputs, voltage, and current.
Details integrated output specifications for digital extensions, including current, protection, and switching.
Details analog input/output specs, ranges, resolution, and tolerances for analog extensions.
Provides specifications for analog outputs, including nominal range, resolution, and cable length.
Explains how to configure analog extensions using DIP switches for channel settings.
Describes how to configure analog extensions using the front panel push button.
Defines the CS31 system bus as RS485, detailing cable specs, length, termination, and amplifiers.
Explains different initialization methods like power-on, warm start, and cold restart.
Lists system constants and their overview, covering operating modes and initialization.
Details operating modes (master, slave, stand-alone) and data backup capabilities.
Explains initialization of digital flags based on system constant KW 00,01.
Details initialization of word/double word flags, step chains, and historical values.
Configures the serial interface for programming, passive, or MODBUS communication.
Explains communication parameters and system constant KW 00,06 for serial interface modes.
Describes how basic units react to different classes of errors, especially Class 3.
Details system constants KW 00,09 for starting the CS31 system after power or restart.
Explains system constants KW 00,10 and KW 00,11 for slave data transfer areas.
Explains how the CS31CO block configures remote units and obtains their configuration.
Explains how 50 series basic units communicate on the CS31 bus as master or slave.
Details CS31 bus addressing for master/slave configuration using system constant KW 00,00.
Explains how to define data volume for CS31 bus communication using system constants KW 00,10 and KW 00,11.
Introduces MODBUS RTU protocol and its application with AC31 units.
Categorizes detected errors into four classes: Fatal, Serious, Light, and Warnings.
Explains how errors are signaled via LEDs and the unit's reaction to errors.
Details methods for acknowledging errors after recovery, categorized by error class.
Details how errors are signaled and provides information regarding error details and acknowledgements.
Explains the meaning of information contained in error word flags, including memory address, unit type, and channel number.
Provides detailed error numbers and information for Class 1, 2, and 3 errors.
Lists Class 4 error descriptions, error numbers, and detailed information fields.
To Next Page
