To Next Page
H
hfdghfdgfdgSep 10, 2025
vdzgvfdgfgdf fd fd fd
vdzgvfdgfgdf fd fd fd
jkjkgj kgh kj kj kgh
Crucial safety warnings to prevent injury, death, or equipment damage during installation.
Determine if capacitors require reforming if the drive has been unpowered for over one year.
Guidelines for selecting, sizing, and protecting power cables and motor connections, including insulation checks.
Instructions for wall mounting the drive and ensuring adequate cooling for optimal operation.
Verifying compatibility with IT/TN systems and instructions for disconnecting EMC filters or varistors.
Detailed steps for connecting motor power, input power cables, and brake resistor cables.
Steps for routing and connecting analog/digital signal cables to the control board.
Diagram illustrating the default Input/Output connections for the ABB standard macro.
Guidance on installing optional modules and reinstalling the drive covers after completing the setup.
General| Control method | Scalar control, Vector control |
|---|---|
| Frequency | 0 to 500 Hz |
| Communication protocols | Modbus RTU, Ethernet/IP, Profibus DP, CANopen |
| Protection features | Overcurrent, overvoltage, undervoltage |
| Enclosure rating | IP21, IP55 |
| Ambient temperature | -15 to +50 °C |
| Storage temperature | -40 to +70 °C |
| Relative humidity | 5 to 95% (non-condensing) |
| Altitude | Up to 1000 m (without derating), up to 4000 m (with derating) |
| EMC Filter | Built-in |
| Voltage range | 208 to 480 V |
| Braking Chopper | Built-in up to 22 kW |
