Need help?Do you have a question about the ABB ACS550 and is the answer not in the manual?
General| Frequency Range | 0 to 500 Hz |
|---|---|
| IP Rating | IP21 (standard), IP55 (optional) |
| Output Voltage | 0 to Input Voltage |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit, Ground Fault |
| Communication Interfaces | RS485, Modbus RTU, Profibus DP (optional), DeviceNet (optional) |
| Ambient Temperature | -10°C to +40°C (without derating), up to +50°C (with derating) |
Details essential steps and checks before proceeding with drive installation.
Gives detailed steps for physically mounting the ACS550 drive unit.
Outlines general requirements and guidelines for wiring the ACS550 drive.
Specific wiring instructions for IP21/UL Type 1 enclosures using cables.
Specific wiring instructions for IP21/UL Type 1 enclosures using conduit.
Specific wiring instructions for IP54/UL Type 12 enclosures using cables.
Specific wiring instructions for IP54/UL Type 12 enclosures using conduit.
Crucial step to check motor and cable insulation before powering up.
Step-by-step guide for initial drive start-up procedures.
Procedure for performing a limited start-up without guided assistance.
Details on manually entering essential start-up data and parameters.
Configures the method for automatic motor identification (ID Run).
Crucial safety precautions to be followed during guided start-up.
Steps for configuring the drive using the guided start-up assistant.
Basic operation of starting and controlling motor speed using I/O.
Guide on utilizing the drive's setup assistants for parameter configuration.
Steps to access and review the drive's fault history.
Detailed steps for editing and changing I/O related parameter settings.
Steps to adjust the speed, frequency, or torque reference in reference mode.
Detailed steps for navigating and modifying drive parameters.
A comprehensive list of all ACS550 drive parameters, codes, and descriptions.
Procedures for physically installing the embedded fieldbus interface.
How the ACS550 reports the three most recent faults to the fieldbus.
Principal means of controlling the drive via fieldbus controller.
Steps to activate serial communication by setting parameter 9802.
Details default communication parameters for FBA modules.
Configuration for enabling drive functions via fieldbus adapter.
Configuring start, stop, and direction control via fieldbus.
How the ACS550 reports and handles faults via fieldbus.
Details the control word content for the ABB Drives profile.
Scaling of actual values based on parameter resolution for fieldbus.
How the drive reports and displays error situations.
How severe errors (faults) are indicated and displayed.
Lists the electrical and mechanical ratings for ACS550 drives.
Specific ratings information for ACS550 drives operating at 208-240 V.
Specific ratings information for ACS550 drives operating at 380-480 V.
Specific ratings information for ACS550 drives operating at 500-600 V.
Specific motor cable requirements for CE and C-Tick compliance.
Details on voltage, frequency, current, and switching frequency for motor connections.
To Next Page
