EasyManua.ls Logo

ABB ACS550 - Applicable Standards; CE Marking; C-Tick Marking

ABB ACS550
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ACS550 User’s Manual 291
Technical data
Applicable standards
Drive compliance with the following standards is identified by the standard “marks”
on the type code label.
CE marking
A CE mark is attached to the drive to verify that the drive follows the provisions of the
European Low Voltage and EMC Directives (Directive 73/23/EEC, as amended by
93/68/EEC, and Directive 89/336/EEC, as amended by 93/68/EEC).
Note: The 600 V ACS550-U1 drives are not CE approved.
Compliance with the EMC Directive
The Directive defines the requirements for immunity and emissions of electrical
equipment used within the European Union. The EMC product standard [IEC/EN
61800-3 (2004)] covers requirements stated for drives.
Compliance with IEC/EN 61800-3 (2004)
See page 293.
C-Tick marking
The drive carries C-Tick marking.
C-Tick marking is required in Australia and New Zealand. A C-Tick mark is attached
to the drive to verify compliance with the relevant standard (IEC 61800-3 (2004) –
Mark Applicable standards
EN 50178 (1997) Electronic equipment for use in power installations
IEC/EN 60204-1 (2005) Safety of machinery. Electrical equipment of machines.
Part 1: General requirements. Provisions for compliance: The
final assembler of the machine is responsible for installing:
an emergency-stop device
a supply disconnecting device.
IEC/EN 60529 (2004) Degrees of protection provided by enclosures (IP code)
IEC 60664-1 (2002)
Insulation coordination for equipment within low-voltage
systems. Part 1: Principles, requirements and tests
IEC/EN 61800-5-1 (2003)
Adjustable speed electrical power drive systems.
Part 5-1: Safety requirements. Electrical, thermal and energy
IEC/EN 61800-3 (2004) Adjustable speed electrical power drive systems.
Part 3: EMC requirements and specific test methods
IEC/EN 61800-3 (2004) Adjustable speed electrical power drive systems.
Part 3: EMC requirements and specific test methods
UL 508C UL Standard for Safety, Power Conversion Equipment, third
edition
C22.2 No. 14 CSA Standard for Industrial Control Equipment (for ACS550-U1
drives only)

Table of Contents

Other manuals for ABB ACS550

Related product manuals