EasyManua.ls Logo

ABB ACS550 - Basic Control Panel

ABB ACS550
310 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
62 ACS550 User’s Manual
Control panels
Basic Control Panel
Features
The Basic Control Panel features:
numeric control panel with an LCD display
copy function – parameters can be copied to the control panel memory for later
transfer to other drives or for backup of a particular system.
Overview
The following table summarizes the key functions and displays on the Basic Control
Panel.
No. Use
1 LCD display – Divided into five areas:
a. Upper left – Control location:
LOC: drive control is local, that is, from the control panel
REM: drive control is remote, such as the drive I/O or fieldbus.
b. Upper right – Unit of the displayed value.
c. Center – Variable; in general, shows parameter and signal values, menus or
lists. Shows also fault and alarm codes.
d. Lower left and center – Panel operation state:
OUTPUT: Output mode
PAR: Parameter mode
MENU: Main menu
: Fault mode.
e. Lower right – Indicators:
FWD (forward) / REV (reverse): direction of the motor rotation
Flashing slowly: stopped
Flashing rapidly: running, not at setpoint
Steady: running, at setpoint
: Displayed value can be modified (in the Parameter and Reference
modes).
2 RESET/EXIT – Exits to the next higher menu level without saving changed
values. Resets faults in the Output and Fault modes.
3 MENU/ENTER – Enters deeper into menu level. In the Parameter mode,
saves the displayed value as the new setting.
4 Up –
Scrolls up through a menu or list.
Increases a value if a parameter is selected.
Increases the reference value in the Reference mode.
Holding the key down changes the value faster.
5 Down –
Scrolls down through a menu or list.
Decreases a value if a parameter is selected.
Decreases the reference value in the Reference mode.
Holding the key down changes the value faster.
6 LOC/REM – Changes between local and remote control of the drive.
7 DIR – Changes the direction of the motor rotation.
8 STOP – Stops the drive in local control.
9 START – Starts the drive in local control.
FAULT
SET
RESET
EXIT
MENU
ENTER
2
3
4
5
6 7
8 9
1c
LOC A
OUTPUT FWD
11
.
1b
1e
1a
1d

Table of Contents

Other manuals for ABB ACS550

Related product manuals