44 ACS550 User’s Manual
Control panels
Initially, the panel is in the Output mode, where you can
start, stop, change the direction, switch between local and
remote control, modify the reference value and monitor up
to three actual values. To do other tasks, go first to the
Main menu and select the appropriate mode on the menu.
The status line (see section Status line on page 43) shows
the name of the current menu, mode, item or state.
How to do common tasks
The table below lists common tasks, the mode in which you can perform them and
the page number where the steps to do the task are described in detail.
Task Mode Page
How to get help Any 45
How to find out the panel version At power up 45
How to adjust the display contrast Output 48
How to switch between local and remote control Any 46
How to start and stop the drive Any 46
How to change the direction of the motor rotation Output 47
How to set the speed, frequency or torque reference Output 48
How to change the value of a parameter Parameters 49
How to select the monitored signals Parameters 50
How to do guided tasks (specification of related parameter sets)
with assistants
Assistants 51
How to view and edit changed parameters Changed Parameters 54
How to view faults Fault Logger 55
How to reset faults and alarms Output, Fault 249
How to show/hide the clock, change date and time formats, set the
clock and enable/disable automatic clock transitions according to
the daylight saving changes
Clock Set 56
How to copy parameters from the drive to the control panel Parameter Backup 59
How to restore parameters from the control panel to the drive Parameter Backup 59
How to view backup information Parameter Backup 60
How to edit and change parameter settings related to I/O terminals I/O Settings 61
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER
00:00
MAIN MENU 1LOC
5 A
1 Hz
7 %10.
0.
49.
49.1HzLOC
DIR
MENU00:00
To Next Page
Loading...
